Joined: Tue Apr 05, 2016 7:58 pm Posts: 1424 Location: San Marcos, CA
Good job, very nice color. Not sure what 3/4.9ct. means? .75 - .90ct is that correct? Possible you just happened to be on the cleavage plane with your table polish issues, and you got passed it just enough to get a decent polish. Thank you for sharing the journey.
Thank you! yeah sorry, .75 - .9 ct it measures 6.2x6.9x3.6 mm yes the cleavage was parallel to the cutting surface for the table, I wasn't sure about that part when I dopped it but it was the best spot to get good contact. I need to get it down bc I'll have to glue like that a lot.
Joined: Tue Apr 05, 2016 7:58 pm Posts: 1424 Location: San Marcos, CA
I know the feeling, sometimes with rough this small and type, it is almost impossible not too. That is what makes faceting sometimes so frustrating, gaining the experience is a rewarding experience in itself.
Users browsing this forum: No registered users and 23 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum